
01Strip and inspect
See the damage before the quote
The engine is stripped far enough to see what’s happened, and each part is checked as it comes off. You hear what we’ve found before the rebuild is priced.

Engine specialists · Ellesmere Port
Timing failures, top-end damage and worn valve gear, found and fixed. Before you pay for a replacement engine, let us look at it.
Other garages often quote a new engine when a timing chain goes or the top end is damaged. We diagnose the actual fault, explain what we find, and repair it in stages you agree to.
01What we repair
Every job starts with finding the fault. Choose one to ask for a quote.
01A chain that’s stretched or snapped, or a belt due by age or mileage. Replaced, and any damage it caused assessed.
02When a failure has damaged the valves or head, we rebuild the top end rather than replace the whole engine.
03Overheating, losing coolant or white smoke. We pressure test and machine the head in-house.
04Ticking, knocking or a sudden loss of power from worn followers, cams or valves.
05Won’t start, misfiring or a warning light. Traced to the cause before anything is replaced.


Before you write it offGet it diagnosed first
02Signs worth acting on
Catching these early often means a smaller repair. If you notice any of them, stop driving if you can and get it checked.


03Head gaskets and overheating
A blown head gasket is usually the symptom, not the cause. Fit a new gasket to a warped or cracked head and the same fault comes back. So the head is checked before anything goes back on.
Coolant loss, white smoke, overheating or warning lights are noted before anything is stripped.
The head comes off and is pressure tested for cracks and leaks.
The gasket face is checked for flatness and skimmed flat if it needs it.
Only once you’ve agreed the work and the cost.
If the head is sound
Skimmed if needed, refitted with a new gasket and back on the road.
If it’s cracked
You’re told before you pay for any machining, with the options explained.
04Engine rebuilds
When a failure has damaged parts inside the engine, we find out exactly what’s affected before anyone talks about a replacement.

01Strip and inspect
The engine is stripped far enough to see what’s happened, and each part is checked as it comes off. You hear what we’ve found before the rebuild is priced.

02Top-end rebuilds
After a timing failure, the damaged valve gear is replaced and the head is pressure tested, skimmed and its seats and valves done in-house.

03If it goes deeper
If the damage reaches further into the engine, we show you what we’ve found and talk through the options, including whether a rebuild still makes sense for the car.
Ask about a rebuild05How a repair works
No surprises. You know what we’ve found, what it costs and how far each stage goes before we start it.
Call or send the registration, the symptoms and anything you’ve been quoted.
The car is diagnosed properly before any parts are ordered.
Big jobs are explained and quoted in stages, so you decide how far to go.
We do the agreed work and talk you through what was done.
“my BMW 3 Series 2014 had a timing chain failure resulting in the top end of the engine getting damaged and not being able to turn over. The engine centre was amazing from the start, after calling them and explaining the issue they were super helpful, explaining once it was at the garage what they would carry out and since it was such a large job they did it in stages to give me the breathing room to let me pick what route I wanted to go”
06Get a quote
Send the registration and what the car is doing, or ring us. We’ll call you back to talk it through.